Bosch Appliances THE DCN

SC & SI Remote Interface Description en | 5

Bosch Security Systems B.V. | 2003 December | SC & SI Remote Interface Description

Some remote functions are supported in more than one system mode, or in an other mode than the congress

system mode.

Init

Download Maintenance

Congress

Down

Config

Figure 1: CCU System modes

Contents

Main Page 1 Introduction 1.1 Purpose 1.2 Scope 1.3 Definitions, Acronyms and Abbreviations 1.4 References 2 System configuration and system installation 2.1 Introduction 2.2 Remote System Configuration and System Installation 2.3 System Modes Page 3 System Configuration Functions 3.1 Introduction 3.1.1 Remote function item explanation 3.2 SC_C_CHECK_LINK 3.3 SC_C_START_DCN 3.4 SC_C_STOP_DCN 3.5 SC_C_GET_CCU_VERSIONINFO Page 3.6 SC_C_GET_CCU_CONFIG 3.7 SC_C_START_DQS 3.8 SC_C_STOP_DQS 3.9 SC_C_MAINT_CCU_DB 3.10 SC_C_DOWNLOAD_CCU_DB 3.11 SC_C_CLEAR_CCU_DB 3.12 SC_C_CCU_APPLY_ONE 4 System Configuration notifications 4.1 Introduction 4.1.1 Update Notification item explanation 4.1.2 Unit/user event relations SC & SI Remote Interface Description en | 16 Bosch Security Systems B.V. | 2003 December | SC & SI Remote Interface Description Remote Controller connected to the Master CCU 4.2 SC_C_CCU_REBOOT 4.3 SC_C_CONNECT_UNIT 4.4 SC_C_DISCONNECT_UNIT 4.5 SC_C_CONNECT_SLAVE_CCU 4.6 SC_C_DISCONNECT_SLAVE_CCU 4.7 SC_C_CCU_MODE_CHANGE 5 System Installation Functions 5.1 Introduction 5.2 SI_C_START_INSTALL 5.3 SI_C_STOP_INSTALL 5.4 SI_C_SELECT_UNIT 5.5 SI_C_SET_MASTER_VOL 6 System Installation notifications 6.1 Introduction 6.1.1 Unit/user event relations 6.2 SI_C_REGISTER_UNIT SC & SI Remote Interface Description en | 23 APPENDIX A. VALUES OF THE DEFINES Page APPENDIX B. ERROR CODES Page APPENDIX C. EXAMPLES C.1. Assigning seats using global installation C.2. Replacing defective units during operation Page APPENDIX D. ERROR CODES