BM 2610925542
•To position switch on the left, line up the base’s arrow with arrow on the motor housing that is below the switch.
3.Slide motor into base until resistance in felt. (The base’s guide pin is now engaged into slot on motor.)
4.Turn the motor clockwise until it stops.
5.Push the motor into the base as far as it will go.
6.Fasten the base clamp lever.
INSTALLING TEMPLET GUIDE ADAPTER
Place templet guide adapter over the holes in the center of the
FIG. 9
TEMPLET GUIDE
ADAPTER
MOUNTING SCREWS
| CHIP DEFLECTOR |
| FIG. 10 | |||
! | WARNING | Always | wear | eye |
| |
protection. | The | chip | ||||
|
| |||||
deflector is not intended as a safety guard.
The chip deflectors help keep dust and chips out of your face, it will not stop objects larger than dust thrown from the bit.
To remove chip shield from bases, press inward on tabs until it releases from base and remove. To attach, place deflector into position as shown in (Fig. 10). Then flex sides of deflector while pushing until it snaps into place. The plunge base’s chip shield can also be flipped out.
10 |
|
0 | 0 |
