2610009642 10/09 E:2610009642 10/09 E 10/20/09 3:17
PM Page 10
Assembly
Tools Needed for Assembly And Alignment
Combination Square | Hex “L” Wrench | Multi Purpose “L” Wrench 6.5mm |
| (supplied) 1.5mm | (supplied with model 5312 only) |
Combination Square Must be True
Multi Purpose Tool (supplied with model 5412 only)
Draw Light
Line on Board
Along this Edge
Should be no Gap or Overlap when Square is Flipped Over in Dotted Position
Straight Edge of Board 3/4" Thick This Edge Must be Perfectly Straight
10mm/17mm Combination Open End Wrench
Disconnect plug from power source before performing any assembly, adjustment or repair to avoid possible injury.
Unpacking And Checking Contents
Before moving the saw: Lock the miter lock knob in 45° position.
Lock bevel lock handle. Pull the head assembly com- pletely toward you and tighten the slide rail lock knob.
Lock head assembly in the down position.
Never carry the tool by the slide rails, this may cause blade damage.
Never carry the tool by the cord or head assembly power switch handle. Damage to insulation could cause an electric shock. Damage to wire connec- tions could cause a fire.
Models 5312 & 5412 Miter Saws are shipped complete in one box.
1.Separate all parts from packing materials and check each one with the “Table of Loose Parts” to make sure all items are accounted for before discarding any packing material.
2.Table of Loose Parts:
Quick- Action Clamp (Model 5412 only) - Used to clamp workpieces.
Workpiece Clamp (Model 5312 only) - Used to clamp workpieces.
Dust Elbow/Dust Bag - Used to collect saw dust.
Multi Purpose Tool (Model 5412 only) - Should be stored on the right rear base.
Rear Cord Wrap, washer and Screw - Used for wrapping the cord
Miter Lock Knob - Used to lock the table at de sired miter angle.
!WARNING If any parts are missing, do not plug in power cord or turn the
switch on until the missing parts are obtained and are installed correctly.
Attaching Miter lock Knob
Locate the miter gauge lock knob from among the loose parts, and thread shaft on lock knob into hole provided.
| Miter Gauge |
UNLOCK | lock Knob |
LOCK |
|
Attaching Rear Cord Wrap
Locate the rear cord wrap from among the loose parts, position rear cord wrap as shown and secure with washer and phillips screw provided.
Rear Cord Wrap
Washer
phillips Screw
