2610009642 10/09 E:2610009642 10/09 E 10/20/09 3:19
PM Page 37
Troubleshooting
Troubleshooting Guide - General
pROBlEM |
| CAUSE | CORRECTIVE ACTION |
|
|
|
|
Blade does not completely cut | 1. | Depth stop screw adjusted | - See Depth Stop Adjustment |
workpiece. |
| for groove cutting. | in the Adjustment section. |
|
|
|
|
Head assembly does not slide | 1. | Slide rail lock knob tight- | - Loosen slide rail lock knob. |
freely when attempting a slide |
| ened. |
|
cut. |
|
|
|
Head assembly slides forward | 2. | Slide rail lock knob not tight- | - Push head assembly com- |
and back when making a chop |
| ened. | pletely against stop. Tighten |
cut. |
|
| slide rail lock knob. |
|
|
|
|
Bevel setting does not hold | 1. | Bevel lock lever assembly | - Tighten bevel lock lever as |
position. |
| needs to be tightened. | shown on page 13. |
|
|
|
|
Accessories
DAf220K Miterfinder™ DigitalAnglefinder/Com- pound Cut Calculator/protractor/level – Gives you the information needed to position cuts so that they fit together precisely even if the room is out of square.
MS1221 Horizontal Quick Clamp Crown Stop Bracket – Clamps workpiece against fence. Can also be used as a crown molding stop. Mounts to left or right side of the table.
MS1222
MS1223 length Stop Kit.
MS1224 Replacement Kerf Inserts
MS1225 Replacement Dust Bag
MS1226 Replacement (Vertical) Quick Clamp T3B TracRac™ portable Stand with Wheels T4B
