Bosch Power Tools 5412L, 5312 manual Bevel Range 1 = 45 left to, Bevel lock lever

2610009642 10/09 E:2610009642 10/09 E 10/20/09 3:18 PM Page 25

Bevel Range 1 = 45° left to 0°

This left side bevel range is the default setting

To operate in range 1:	45 - 0
1. Move the left sliding fence to clear
saw assembly and re-lock (Figure 29).
2. Lift bevel lock lever to the table height	Left
with the left hand (Figure 30).

3.Grasp the front carry handle with the right hand and tilt saw head to angle desired.

4.Once in the desired bevel position, fully press down bevel lock lever below table height (Figure 29)..

Without turning the saw on, practice the cutting ac- tion to make sure the fence clears the guards and adjust as necessary.

Bevel Range 2 = 0° to 45° Right	0- 45
To operate in range 2:

1.Move right sliding fence to clear Right saw assembly and re-lock (Figure

29).

2.Lift bevel lock lever to the table height with the left hand (Figure 30).

3.Grasp the front carry handle with the left hand and tilt saw head slightly to the left while rotating the spring-loaded bevel range selector knob with the right hand so the symbol “ 45-0° “ lines up with the arrow on the table (Figure 31). The saw as- sembly may now be tilted to a right bevel angle up to the 45° stop.

4.Once in the desired bevel position press down bevel lock lever below table height.

sembly may now be tilted to any angle from 47° left to 47°right.

4.Once in the desired bevel position, fully press down bevel lock lever below table height.

follow these instructions for making your bevel cut:

5.Extend the base extensions and fence on the side on which the cut will be made. (See Sliding Fence and Base Extension on page 22).

6.Properly position workpiece. Make sure work piece is clamped firmly against the table and the fence.

Use clamping position that does not interfere with operation. Before switching on, lower head assem- bly to make sure clamp clears guard and head as- sembly.

7.Follow the procedures for either a chop cut or slide cut (see page 23).

8.Wait until blade comes to a complete stop before returning head assembly to the raised position and/or removing workpiece.

front Carry Handle

NOTE: When the saw assembly is tilted back left past 0°, the bevel control knob will snap back to the default bevel range 1. This is designed to regain the pre-set bevel stop at the important 0° position.

Bevel Range 3 = 47° left to 47° Right

This full capacity bevel range setting overrides all preset stops and allows for cutting at bevel angles beyond the normal 45° on either side.

To operate in range 3:	47- 47
1. Move left and right-sliding fences
to clear saw assembly and re-lock	Max
(Figure 29).

2.Lift bevel lock lever to the table height with the left hand (Figure 30).

3.Grasp the front carry handle with the left hand and tilt saw head slightly to the left while rotating the spring-loaded bevel range selector knob with the right hand so the symbol “ 47-47° “ lines up with the arrow on the table (Figure 31). The saw as-

Sliding fence

UNLOCK

LOCK

figure 29.

Bevel lock lever

figure 30.
	Bevel
	Range
	Selector
figure 31.	Knob

-25-