BM 2610919169
Operating Instructions
DEPTH ADJUSTMENT
Your saw is equipped with a depth detent system that will stop the foot at 2x, 3/4", 1/2", and 1/4" standard lumber depths.
Disconnect plug from power source. Loosen the depth adjustment lever located in the housing of saw. Hold the foot down with one hand and raise or lower saw by the handle.
FIG. 3
CALIBRATED
DEPTH BRACKET
ADJUSTABLE
DEPTH LEVER
2
1FOOT
Tighten lever at the depth setting desired. Check desired depth (Fig. 3).
Your saw also features a adjustable depth adjustment lever for consistent locking. To adjust, simply pull outward on lever and reposition to desired position (Fig. 3).
Not more than one tooth length of the blade should extend below the material to be cut, for minimum splintering (Fig. 4).
FIG. 4
ONE TOOTH LENGTH SHOULD
PENETRATE WOOD FOR
MINIMUM SPLINTERING
90° CUTTING ANGLE CHECK
Disconnect plug from power source. Set foot to maximum depth of cut setting. Loosen bevel adjustment lever, set to 0° on quadrant, retighten lever and check for 90° angle between the blade and bottom plane of foot with a square (Fig. 5). Make adjustments by turning the small alignment screw from bottom side of foot, if necessary.
FIG. 5
FOOT
BLADE
BEVEL
ADJUSTMENT
LEVER
|
|
| ALIGNMENT | |
|
|
| ||
90° | ||||
|
| SCREW | ||
|
|
|
BEVEL ADJUSTMENT
Your saw is equipped with a bevel detent system that will stop the foot at 22.5°, and 45° angles.
Disconnect plug from power source. The foot can be adjusted up to 56° by loosening the bevel adjustment lever at the front of the saw. Align to desired angle on calibrated quadrant. Then tighten bevel adjustment lever (Fig. 6).
Your saw also features a adjustable bevel adjustment lever for consistent locking. To adjust, simply pull outward on lever and reposition to desired position (Fig. 1).
Because of the increased amount of blade engagement in the work and decreased
stability of the foot, blade binding may occur. Keep the saw steady and the foot firmly on the workpiece.
FIG. 6
QUADRANT
BEVEL
ADJUSTMENT
LEVER
