Bosch Power Tools DAF220K manual Transferring of Angles See Figure D, Protractor

daf220_bu_2609140572_003.fm Seite 11 Montag, 8. September 2008 2:22 14

11

–The leg extension can be extend- ed out up to 6-3/4" or 170 mm (see Figure A).

–When the extension is used in this way, the “tool-interior an- gle” w is displayed though it is the “tool-exterior angle” v that is needed (see Figure G). To determine the “tool-exterior angle”, subtract displayed angle measurement from 180°

(v = 180°–w).

Examples of Leg Extension Usage

–Figure G illustrates the measure- ment of a stairway step’s angle.

–Figure H illustrates the measure- ment of the angle of the top of a ventilation shaft that is to be covered.

–Figure I illustrates the measure- ment of a sloped window’s angle.

Transferring of Angles

(See Figure D)

The Miterfinder™ can also be used to copy existing angles from one lo- cation to another:

1Measure the angle to be copied and keep the tool opened to that angle.

2Place the contact edges of the tool onto the structure or work- piece and use the tool as a straight edge to mark both legs of the intended angle location.

Protractor

The Miterfinder™ can also be used to position a workpiece or intended cut line at exactly the desired angle

1Open the tool to the desired angle.

2Please the tool into the intended position of the work.

3Use the tool as a straight edge to mark both legs of the intended angle location.

Bosch Power Tools 2 609 140 572 (8.9.08)