daf220_bu_2609140572_003.fm Seite 12 Montag, 8. September 2008 2:22 14
12
HOLD (Memory)
The hold memory is a
–For storing a specific angle value will be used repeatedly in com- pound cut calculations, such as the common 38° crown molding spring angle.
–For storing an angle measured in a confined situation …
y when the display cannot be seen when the measurement is taken and
y when it is necessary to fold the leg to move the tool so that the display can be seen. (For example, when measur- ing the angle of eaves from an attic.)
Procedure
To store an angle in the HOLD memory,
–Press the RECALL/HOLD button 5 for more than 1 second.
–The display and HOLD indicator g blink twice of to confirm the suc- cessful storage of the angle.
To recall the stored angle, simply press the RECALL/HOLD button 5 for less than 1 second. The recalled angle then flashes in the display.
Notes:
–The tool maintains the stored angle even after the tool is shut- off manually or automatically.
–However, if the battery power is exhausted or when the batteries are removed, the stored angle will be lost and need to be re- stored after new batteries are in- stalled.
–If the HOLD button is pressed for more than 1 second when 0.0° is the displayed angle, any stored angle is deleted.
2 609 140 572 (8.9.08) | Bosch Power Tools | ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
