BM 2610021461
5.Lightly press centering sleeve into
6.Tighten the
7.The precision centering of the subbase or templet guide is complete.
CENTERING CONE – Used when centering the subbase itself or wide templet guides.
CENTERING SHAFT (optional accessory)
TEMPLET GUIDE
(optional accessory)
CENTERING CONE | CENTERING SHAFT |
(optional accessory) | (optional accessory) |
|
|
SUBBASE
FIG. 47
PLUNGE BASE
MAXIMUM BIT/CUTTER SIZE FOR
TEMPLET GUIDES
When using a templet guide, use only router bit with cutters that are 1/16” less than the internal diameter of the templet guide, such as in the table below.
USE WITH THREADED
TEMPLET GUIDES
Also available as an optional accessory is an additional adapter, the RA1100, that allows use of conventional threaded templet guides with the Bosch
Bosch | Bushing | External | Internal | Max |
Templet | Depth | Diameter | Diameter | Bit/Cutter |
Guide | A | B | B | Diameter |
|
| |||
RA1101 | 3/16” | 5/16” | 1/4” | 3/16” |
RA1103 | 9/64” | 5/16” | 17/64” | 13/64” |
RA1105 | 9/64” | 7/16” | 3/8” | 5/16” |
RA1107 | 5/16” | 7/16” | 3/8” | 5/16” |
RA1109 | 7/16” | 1/2” | 13/32” | 11/32” |
RA1111 | 3/16” | 5/8” | 17/32” | 15/32” |
RA1113 | 1/2” | 5/8” | 17/32” | 15/32” |
RA1115 | 3/16” | 3/4” | 21/32” | 19/32” |
RA1117 | 31/64” | 13/16” | 5/8” | 9/16” |
RA1119 | 31/64” | 1” | 25/32” | 21/32” |
RA1121 | 7/16” | |||
|
|
|
|
|
