BM 2610021461 06-12_BM 2610021461 06-12.qxp 6/26/12 1:38 PM Page 22
PR008 BASE COVER
(Included with PR004 Offset Base. Also
available as optional accessory)
The optional PR008 Base Cover (Fig. 37) is available to provide insulation from tool heat in continuous and/or
Installation of Base Cover
1.Remove clamp.
2.Slide cover over the top of the base and into position
3.Reattach clamp. Make sure that washers sit on outside of cover.
FIG. 37
BASE
COVER
REMOVE CLAMP
PR011 PLUNGE BASE To install motor in plunge base:
1.Release the base clamp lever.
2.Line up the double triangle on the base with double triangle on the motor. (Fig. 38)
•To position switch on the right side of the base, line up the base’s arrow with arrow on the motor housing that is below the cord.
•To position switch on the left, line up the base’s arrow with arrow on the motor housing that is below the switch.
3.Slide motor into base until resistance in felt. (The base’s guide pin is now engaged into slot on motor.)
4.Turn the motor clockwise until it stops.
5.Push the motor into the base as far as it will go.
6.Fasten the base clamp lever.
FIG. 38
BASE
CLAMP
LEVER
DEPTH ADJUSTMENT
The plunge feature simplifies depth adjustments and will allow the cutting bit to easily and accurately enter the workpiece.
1.To lower, push plunge lock lever to the left, apply downward pressure until you reach desired depth, and release pressure on lever to lock (Fig. 39). The plunge lock lever is spring loaded and returns automatically to the locked position.
2.To raise the router, push plunge lock lever to the left, release pressure on router and the router will automatically retract the bit from the workpiece. It is advisable to retract the bit whenever it is not engaged in workpiece.
FIG. 39
