Bose 10 Series II Setting Up, Check the connections, Attach the module end cover, if desired

Setting Up

Check the connections

Check all connections from the receiver to the Acoustimass® module and the module to the cube speakers (Figure 9). Make sure all speakers are connected to the proper terminals according to their position in your room.

At the receiver, check that the wires are connected in phase (+ to + and – to –). Incorrect wiring can result in a total loss of Acoustimass module output.

Be sure to correct any wiring problems before you plug your receiver in and turn it on.

CAUTION: Do not allow exposed wires to brush against each other; this could damage your receiver.

Figure 9

R

Completed connections

C

L

FRONT SPEAKERS		SURROUND SPEAKERS
R	L	R REAR L CENTER

RS LS

OUTPUTS

TO CUBE SPEAKERS

L C R LS RS

LEFT	CENTER	RIGHT	LEFT	RIGHT
			SURROUND	SURROUND

INPUTS

FROM RECEIVER OR AMPLIFIER

L C R LS RS

Attach the module end cover, if desired

The module end cover is designed to hide the cabling and extend the smooth, clean lines of the Acoustimass module. However, because the cover has a beveled surface, you cannot stand the module on that end with the cover in place.

If you plan to use the cover, attach it to the cable end after all connections have been checked (Figure 9). Gently push the end cover into the grommets on the Acoustimass module (Figure 10).

Your set-up is complete. Enjoy your Acoustimass 10 Series II speaker system.

Figure 10

The module end cover fits over the cables

12 October 22, 2001 AM19464_02_V.pdf