6. Specification |
|
General Specification |
|
Power Supply Requirement | DC 12V |
Maximum Power Output | 4 x 85W(measured at DC 14.4 V) |
Dimensions(w x h x d) | 7”W x 2”H x 6.3”D |
DVD Deck Specification |
|
Format | DVD/VCD/JPEG/MP4/MP3/WMA/CD |
Video System | NTSC |
Audio System | 24 bit/96KHz |
Loading System | Auto Loading |
Mounting Angle | 0 to |
Video Specification |
|
Video Type | 16:9 and 4:3 |
Video Output level | Composite:1.0± |
| Load impedance: 75 ohms |
Horizontal Resolution | 500 |
Audio Specification |
|
Audio Output(Analog audio) | |
Frequency Response | 20Hz ~ 20KHz(at 1KHz 0 dB) |
S/N Ratio(Audio) | ≥90dB(at 1KHz 0 dB) |
Separation | 50dB |
Radio Specification |
|
FM Section |
|
Frequency range | 87.5MHz - 107.9MHz(US) |
| 87.5MHz - 108.0MHz(EU) |
Usable sensitivity | 3uV |
I.F Frequency | 10.7MHz |
AM Section |
|
Frequency | 530KHz - 1710KHz(US) |
| 522KHz - 1620KHz(EU) |
1.3Maintenance and Cleaning of Discs Disc Maintenance
1.To keep the disc clean, handle the disc by its edge, do not touch the disc surface of the play side.
2.Do not stick paper or tape on the disc. If there is anything on the disc surface, wipe it up with a soft cloth before using.
3.Do not expose the disc to direct sunlight, or nearby heat sources such as caliduct, or leave it in a car parked in direct sunlight where there can be a considerable rise in temperature.
4.Put the disc inside disc case to keep temperature after finishing playback.
Disc Cleaning
1.Before playing, wipe the disc with a clean cloth. wipe the disc outwards from the disc center.
2.Do not use petrol, thinner. Commercial cleaner or
+ side up
|
| B |
|
| A |
Fig.1 | Fig.2 | Fig.3 |
1.4 Battery Information of the Remote Control
Replace Battery in the Remote Control:
1.Before using the remote control for the first time, pull the insulating sheet out of the remote control as the direction indicated by the arrow.(see fig.1)
2.Press the movable block hold as the direction indicated by the A arrow (See fig.2), then pull the battery holder out of the remote control as the direction indicated by the B arrow(see fig.2).
3.Replace the old battery by a new battery with (+) polarity side upward. (See fig.3).
4.Insert the battery holder to the original position in remote control. (See fig.3).
Note about the Battery of the Remote Control:
1.Improper use of battery may cause overheating or explosion. 2.Battery leakage may cause damage to the remote control(Battery
Life: 6 months with normal use in normal room temperature). 3.Do not short the battery.
4.Do not throw the battery into the fire.
5.To avoid the risk of accident, keep the battery out of reach of children.
PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com
