Creating Sounds (Eects)
28
Mixer settings
1. Press the [EFFECT ] button.
2. Use knob [4] to select “MIXER.”
3. Use knobs [5]–[7] to make settings.
Con-
troller Parameter Value Explanation
[5] MODE
STEREO Channels “A” and “B” will be
mixed and output in stereo.
L/R PAN
Channels “A” and “B” will be
assigned respectively to the L
and R OUTPUT jacks.
[6] CH A/B
BALANC 100:0–0:100
Adjusts the volume balance of
channels “A” and “B.”
* This is shown only if DIVIDER
MODE is set to “DUAL.”
[7] SPREAD 0–100
Slightly delays the sound of
channel “B” to make the sound
more spacious.
* This is shown only if DIVIDER
MODE is set to “DUAL.”
Using Amp ControlBy connecting your guitar amp’s channel switching jack to the GT-
100’s AMP CONTROL jack, you can then use Amp Control to switch
the amp channel.
This combining of the GT-100 and the amp channels allows you
to get an even wider variety of distortion sounds. Since the Amp
Control setting is handled as one of the eects parameters saved to
each individual patch, it allows you to switch guitar amp channels
with each patch.
1. Press the [EFFECT ] button.
2. Use knob [4] to select “MASTER SETTING”.
3. Press the PAGE [ ] button to access page 4.
4. Use knob [5] to switch the setting on/o.
Con-
troller Parameter Value Explanation
Page 4
[5] AMP CONTROL
OFF
Guitar Amp
(Channel switching jack)
GT-100
(AMP CONTROL jack)
ON
Guitar Amp
(Channel switching jack)
GT-100
(AMP CONTROL jack)
* To determine how the amp channels are switched when the
circuit is open and shorted, refer to the amp owner’s manual, or
actually conrm the sounds by operating the amp.
* Note that, depending on the circuitry of the channel switching
jack in the guitar amp used, the Amp Control function may not
operate.
* Since this is a single mono plug, it can’t switch a three-channel
amp.
MEMO
With Amp Control, not only can you switch amp channels,
you can also use it to switch the amp’s eects on and o, like a
footswitch controller.