Boss Audio Systems manual Editing Your Patch, Using the GT-10B’s Onboard Phrase Looper

2

TBS262

b®			GT-10BBASS EFFECTS PROCESSOR
	Editing Your Patch			6	When you’re ready to overdub, press the same BANK 6pedal again—the LED turns
	Within a GT-10B patch, any effect and/or amp model can be easily edited or “tweaked” to				red once more as you overdub on top of your loop.
				7	Press the BANK 5pedal again to stop overdubbing. You can repeat the overdubbing
	sound exactly the way you want. In the example below we’ll turn on and adjust the delay,				process as many times as you wish.
	but you can use the same procedure for reverb, chorus, preamp, FX-1, FX-2, and so on.			8	To stop and clear your loop, press the BANK 5 pedal.
1		Select a patch you want to edit.		9	Now the Phrase Looper is ready to record a new loop. If you’re finished looping,
					press both BANK 6 and BANK 5 pedals simultaneously to turn the Phrase Looper
2		Press the DELAY button until it lights up, and delay parameters appear in the
					off.
		display. (If the delay button is already lit, you only need to press DELAY once).
3		There are two editing views available in the GT-10B: Knob view and List view. Press		Note: Creating loops with the GT-10B requires that you start and end recording in rhythm
		the DISPLAY MODE button to toggle between the two. Let’s select the Knob view,		to make your loop sound even. It’s often best to start recording your loop at exactly Beat 1
		because knobs are easy and intuitive to work with.		of the measure, and stop recording exactly at Beat 1 of a later measure. This may take some
	Tip: There are some parameters that are only available in the List view. When you’re in Knob			practice. Remember that the GT-10B’s loop points are set exactly at the point you press the
				pedal.
	view, use the DISPLAY MODE button to toggle in and out of List view.
4		Use the real knobs under the virtual knobs in the display to change your delay		Tip: While you’re recording and overdubbing with the Phase Looper, you can change
				patches. You may even want to create a bank of patches designed for looping.

settings as desired.

Tip: The 34buttons on either side of the big dial may reveal additional editing pages.

5Press the WRITE button.

6Turn the big dial to select a user patch location, from U01-1 to U50-4.

7 Press the WRITE button again to finish saving your patch.

Using the GT-10B’s Onboard Phrase Looper

1Select the patch you want to use as you record your loop.

2Press both BANK 6and BANK 5pedals simultaneously to turn the looper on—the REC/DUB LED lights up red and flashes to show you’re ready to record.

3To begin recording, press the left BANK 6 pedal. The red LED glows solidly and the GT-10B immediately starts recording whatever you play. You can record for up to 38 seconds.

4When you’re finished recording, press BANK 6 again. This sets the end point of your loop and the GT-10B immediately begins looping what you just played. The

LED glows green.

5You may play over your loop as much as you want.

©2008 Roland Corporation U.S. www.BOSSUS.com