OPERATING INSTRUCTION
1. Simple steps to use cooling mode
Plug in the power cord and press the “POWER” button Press “MODE” to chose COOLING mode.
Press “UP” or “DOWN“ to set the desired temperature. The temperature ranges from 59F to 86F(15C~30C)
Press, “SPEED” to set a desired fan speed.
The fan will run first. After few minutes, the compressor will start to run if the room temperature is higher then the setting temperature. The compressor will stop running when the room temperature is below the setting temperature.
2.Setting the timer
(1)Turn off the unit automatically:
When the unit is running, press TIMER to set operating duration, and then the LED will flash five times. During this period of time, press Up or Down button to adjust setting time from 0.5 hr. to 24 hr. After setting, the LED will flash five times and then display the room temperature again. When the operating duration reaches the
(2)Turn on the unit automatically:
When the unit is off, press TIMER to set start time, and then the LED will flash five times. During this period of time, press Up or Down button to adjust setting time from 0.5 hr. to 24 hr. After setting, the LED will flash five times and then display the temperature again. Once the
(3)Change the setting:
When TIMER is on, you can check the remaining time by pressing the TIMER button. It will flash five times. Press Up or Down button to adjust the timer. The timer can be canceled if you press the TIMER button once again when LED is flashing.
Attention:
If the unit is suddenly turned off during operation, the compressor will start to run three minutes after the power is turned back on.
3.Setting operating mode
COOLING: When this mode is selected, the fan will run first and then the compressor will start to run five minutes after the power is on. To set your desired temperature, press UP or DOWN button. The temperature ranges from 15C~30C (59F~86F). When the room temperature is lower than the setting temperature, the compressor will stop running until the room temperature is higher than setting temperature. In this case, only the fan will keep running.
FAN: When this mode is selected, the temperature setting cannot be changed, but you can set your desired speed. There is no need to use the air exhaust duct in this mode.
DEHUMIDIFING: When this mode is selected, it presets the fan speed and mode, and these settings cannot be changed. Under this mode, the compressor will not run, and LED will display room temperature. There is no need to use the air exhaust duct. You may need to drain water with the drain pipe if the humidity is very high.
4 .Setting temperature
In COOLING mode, press the “UP” button to increase the temperature setting or press the “DOWN
“button to lower the temperature setting. When the number is flashing, it indicates the temperature you are setting up. When the number is lit but not flashing, it indicates the current room temperature.
5.Setting fan speed
In COOLING and FAN mode, press “SPEED” to adjust the fan speed. There are high, medium and low modes. Each fan speed corresponds to one indicator on LED control panel. Please note: when unit is in dehumidifier mode, the fan speed cannot be adjusted.
- 10-