40

LIGHTING AND SHUT-DOWN INSTRUCTIONS

Figure 26. Lighting Instruction Label

WARNING:

above on this label.
on this label if you don't smell gas,
"B" in the safety information above
If you then smell gas, STOP! Follow
6. Wait (5) minutes to clear out any gas.
may result causing property damage, personal injury or loss of life.
If you do not follow these instructions exactly, a fire or explosion
1. Set the thermostat to lowest setting.
2. Set the thermostat to lowest setting.
1. STOP! read the safety information
TO TURN OFF GAS TO APPLIANCELIGHTING INSTRUCTIONSFOR YOUR SAFETY READ BEFORE LIGHTING
A
. This appliance does not have a pilot.
It is equipped with an ignition device
which automatically lights the burner.
Do not try to light the burner by hand.
B. BEFORE OPERATING smell all around
the appliance for gas. Be sure to
smell next to the floor because some
gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electric switch;
do not use any phone in your building.
If you cannot reach your gas
supplier, call the fire department.
C. Turn off main power to the wate
r
heater.
D. Do not use this appliance if any part
has been under water. Immediately
call a qualified service technician to
inspect the appliance and to replace
any part of the control system and
any gas control which has been
under water.
3. Turn off all electrical power to the
appliance.
4. This appliance does not have a pilot.
It is equipped with an ignition device
which automatically lights the burner.
Do not try to light the burner by hand.
5. Turn off the main power switch.
go to next step.
7. Turn on main power.
2. Turn off the main power switch.
8. Set the thermostat to desired setting.
TEMPERATURE UP
TEMPERATURE DOWN
"GREEN LIGHTED" MAIN POWER SWITCH
Immediately call your gas supplie
r
from a neighbor's phone. Follow the
gas supplier's instructions.