Bradley Smoker CRS-2/IR, CRS-3/IR Electrical and supply connections, to the sensor

	Express® Crescent® Lavatory System - CRS-Series
Installation Instructions	CRS-2/IR, CRS-3/IR

Installation Instructions continued . . .

Step 8: Electrical and supply connections

NOTE: Refer to Figure 6a below for CRS-2/IR or Figure 6b on page 8 for CRS-3/IR.

WARNING:	The Adaptive® Infrared control must be connected with a 24 VAC
	Class II transformer. Connections to 110 VAC will result in damage to
	the electronics and can cause personal injury.
CAUTION:	Connection of leads other than shown may cause permanent damage
	to the sensor.

NOTE: Compliance and conformity to local codes and ordinance is the responsibility of the installer.

NOTE: The solenoid valves have been pre-wired.

1.Snap the senser circuit plug from the bowl into the solenoid circuit plug located on the valve bracket.

2.Snap the transformer circuit plug into the female transformer circuit plug located on the valve bracket.

3.Turn on the water supply to the Express® Crescent® Lavatory System and check for leaks.

4.Plug in the transformer and wait at least two minutes to allow the sensor to adapt to the environment.

5.Pass your hand in front of each station’s sensor until all the air is purged from the lines and water is flowing smoothly.

NOTE: The Vernatherm mixing valve is NOT factory preset. Upon installation, the temperature of this valve must be checked and adjusted to ensure delivery of a safe water temperature. Water in excess of 110°F (43°C) may cause scalding.

GREEN SUPPLY TUBE	RED SUPPLY TUBE
(FROM SPRAYHEAD)
SENSOR CIRCUIT PLUG	(FROM SPRAYHEAD)
	COMPRESSION NUT
	(110-231)
TRANSFORMER
CIRCUIT PLUG
	RED SPADE TERMINAL
	WHITE SPADE TERMINAL
Figure 6a	GREEN SPADE TERMINAL
Bradley Corporation • 215-1330 Rev. K; EN 06-915	2/8/07	7