Bradley Smoker CRS-3/IR, CRS-2/IR installation instructions Connecting Supply, Install drain spud

Express® Crescent® Lavatory System - CRS-Series
CRS-2/IR, CRS-3/IR	Installation Instructions

Installation Instructions continued . . .

Step 6: Install drain spud

1.Assemble the P-trap by (supplied by installer) connecting the 1-1/2" tubular pipe to the 1-1/4" tailpiece and to the 1-1/2" drain pipe stubbed out of the wall (see Figure 4).

Step 7: Connecting Supply

1.Connect the 1/2" NPT female end of the stop/check valves to the rough-ins.

2.Connect one end of the supply hoses to the stop/check valves.

IMPORTANT: The hose attached to the hot water inlet of the Vernatherm™ TMV valve must be connected to the hot water rough-in.

DRAIN ASSEMBLY

STRAINER	1/4" RUBBER
AND	WASHER
TAILPIECE
269-1584	FIBER
	WASHER
	NUT

	TRIM TO FIT
P-TRAP
(polypropylene)	Figure 4
269-1697

3.Connect the other end of the supply hoses to the Vernatherm™ TMV valve assembly.

4.OPTIONAL SINGLE-TEMPERED SUPPLY: Attach the stop/check valve to the 1/2" tempered supply line. Connect the stop/check valve to the solenoid valve with the flexible supply hose.

NOTE: The thermostatic mixing valve requires at least 115° F water from the hot water side for proper operation. As with all lavatories, there will be a delay in obtaining warm water. If the hot water is too far away from the washfountain, a circulating pump may be required.

	VERNATHERM™
	MIXING VALVE
	COLD SUPPLY INLET
		HOT	COLD
			SUPPLY
		SUPPLY
	VALVE		STOP/CHECK
	MOUNTING
			VALVE
	BRACKET
	VERNATHERM™
	MIXING VALVE
	HOT SUPPLY INLET		FLEXIBLE
			SUPPLY HOSE
	Figure 5
6	2/8/07	Bradley Corporation • 215-1330 Rev. K; EN 06-915