Braun 32899 Rev A manual QHHO2YHUULGHHDWXUHV 

.QHHO2YHUULGH)HDWXUHV

In the event the Rampvan is in the kneeled position and you experi- ence power or equipment failure, an electrical override and a me- chanical override are available to raise the rear of the vehicle. The vehicle cannot be lowered using override features.

Use the Electrical Override Switch if possible (details at right). The rear of the vehicle can be raised using the mechanical override

if there is an electrical problem (manual procedures). See Kneel Mechanical Override on next page.

Do not drive the Rampvan with the rear of the vehicle in the lowered position. Attempting to do so will result in an extremely rough and unstable ride.

In the event of a kneel system failure, have the kneel system repaired immediately. Contact your sales representative or call The Braun Corporation at 1-800-THE LIFT®. One of our national Product Support rep- resentatives will direct you to an authorized service center.

.QHHO(OHFWULFDO2YHUULGH

The Kneel Override is avail- able to electrically power the kneel system direct (by-pass- ing the electronic control system). The Kneel Override Switch is located on the pas- senger side C-pillar (rear of the slide door).

OPERATION

Press and hold the switch to re- lease the kneel system (raise ve- hicle). Release the switch when the rear of the Rampvan has raised fully. The kneel actuator motor will ratchet (make clicking sound).

3UHVVDQGKROG this switch to release kneel (raise vehicle).

Kneel Override Switch

Page 17