eco normal intensive
cartridge | full |
| empty |
1
2
Description
1Special cord set
2«start cleaning» button
3
4Station lift button for cartridge exchange
5Display for cleaning programs
6Display for cleaning fluid status
7Station mains socket
8Cleaning cartridge
9Shaver foil protection cap
10Shaver foil
11Cutter block
12Foil release buttons
13Long hair trimmer
14
15Switch
16Shaver display
17Info key
18Pilot light
19Shaver mains socket
Before shaving
If you wish, you may start shaving right away (if the shaver is charged, see section «Shaver display»). However, we recommend to follow the procedure described here:
•Using the special cord set (1), connect the mains socket of the Clean&Renew™ station (7) to an electrical outlet.
•Press the station lift button (4) to open the housing.
•Hold the cleaning cartridge (8) down on a flat, stable surface (e.g. table).
•Carefully remove the lid from the cartridge.
•Slide the cartridge into the base of the station as far as it will go.
•Slowly close the housing by pushing it down until it locks.
24
