Braun Hot Beverage Machine manual How to use the machine – Auto Mode

How to use the machine – Auto Mode

XAM

Auto

Manual

Heating

Standby

1Rinse and fill the water container with fresh, cold water. Turn on the machine by pressing the on/off switch. Ensure that the water container is properly inserted in the slot on the back of the machine. Open the brew mechanism. Opening the brew mechanism will initiate the heating of the water and the HEATING light will flash.

2Place a clean cup on the cup stand, adjusting the height of the stand up or down so that the rim of the cup is close to the brew mechanism.

•To adjust the cup stand, insert your finger in the center of the stand, lift and turn.

•To avoid spilling over, please choose the right sized cup for

the drink you are making. See page 3 “Tips for the Perfect Cup.”

3Position your choice of T-DISC on the T-DISC holder, label facing down. Firmly close the brew mechanism by pressing the clamp down until it shuts. The HEATING light may flash again as the machine heats the water to the required temperature for your drink.

4When the AUTO light illuminates, press and release the start/stop button. Brewing will start automatically. There may be a short pause during brewing; this is normal and is designed to draw out the full flavor of your drink. The AUTO light flashes throughout the brew cycle. When the machine has finished brewing, the indicator light will move from AUTO to MANUAL and then, after a delay of 30 seconds, to HEATING.

•When the indicator light moves to MANUAL, you can customize your cup as described in “Manual Mode” (see page 8).

•Once the liquid has begun to flow into your cup, you can stop the brew cycle by pressing and releasing the start/stop button. The machine will stop and any remaining liquid inside the T-DISC will empty into the cup.

5Open the brew mechanism, remove the T-DISC and discard. Your drink is now ready to be enjoyed.

You can prepare the next beverage right away by repeating steps 2 – 5.

•Always remove the used T-DISC from the machine right after brewing. When removing the T-DISC, handle it by the thumb tab to avoid contact with heated areas.

•Please ensure that there is enough water in the water container. If the water level is too low, all the indicator lights will flash, signalling that the water container needs to be refilled.

•If the water level runs low while you are preparing a beverage, simply remove and refill the water container. Once the water container is replaced, brewing will continue automatically where it left off.

6 How to use the machine – Auto Mode How to use the machine – Auto Mode 7