Braun Hot Beverage Machine Preparing your machine for use, 3 4 5, Please Note, brewing continues

Models: Hot Beverage Machine

1 31
Download 31 pages 56.52 Kb
Page 5
Image 5
Preparing your machine for use

Preparing your machine for use

IMPORTANT

Before using your Tassimo machine for the first time, it must be prepared by following the procedure below. Note: it is normal for all the lights to flash when

you turn on the machine. Complete these simple steps to begin enjoying your favorite drinks.

PLEASE NOTE:

For some drinks, the brew cycle includes a 5

to 10 second pause after the initial influx of

water. This pause is normal and allows the

water to fully saturate the product before

brewing continues.

1

2

Rinse the water container, fill it to “max” with fresh, cold water and place it on the machine. Check that the water container is properly inserted in the slot on the back of the machine. Connect the machine to the electrical supply and press the on/off switch located on the back of the machine. All the indicator lights will flash.

Place a large cup (at least 11 oz/325 ml) on the adjustable

M a

XAM

PLEASE NOTE:brewing continues. 0

• Never open the brew mechanism during brewing.

In “Auto Mode,” always wait for the indicator light

to move from AUTO to MANUAL before opening

the brew mechanism. In “Manual Mode,” take

your finger off the start/stop button and wait

until the machine has stopped before opening

the brew mechanism.

• Always use care when removing your finished beverage.

3

4

5

cup stand. Open the brew mechanism, position the cleaning disc (included in your package) on the T-DISC holder, bar code facing down. Firmly close the brew mechanism by pressing the clamp down until it shuts.

Wait five seconds then press and release the start/ stop button to start the machine. You will hear the machine run for a short period to fill the internal water heater. When the machine stops running, the STANDBY light will illuminate.

Open the brew mechanism and close it again, leaving the cleaning disc in place. The orange HEATING light will begin to flash. Wait about a minute until the green AUTO light illuminates, then press and release the start/stop button. The machine will fill the cup with water. When the machine stops running, empty the cup and place it back on the adjustable cup stand. Repeat this step once more in its entirety.

Open the brew mechanism and remove the cleaning disc. The HEATING light will illuminate. Your machine is now ready to use.

the brew mechanism. Auto

3 Auto

the on/off switch. Manual

the water container. Heating

Manual background Standby

click

The beverage may be hotter than you expect.

• After 10 minutes of non-use, the STANDBY light

will illuminate. If you are not going to use your

machine for an extended period, turn it off using

the on/off switch.

• This appliance is intended for household use only.

• Place the appliance on a dry, flat and fixed surface

and keep it out of reach of children.

• Never use warm water, sparkling water or milk to fill

the water container.

• This machine is not suitable for use at altitudes

above 6500 feet/2000 meters.

• Braun electric appliances meet applicable

safety standards. Repairs on electric appliances

(including cord replacement) must only be

carried out by authorized Braun service centers.

Faulty, unqualified repair work may cause

accidents or injury to the user.

Do not discard the cleaning disc after use – you will need it for flushing and descaling the appliance.

Manual backgroundTASSIMO

Manual background Auto

4 Preparing your machine for use

Preparing your machine for use 5

Page 5
Image 5
Braun Hot Beverage Machine manual Preparing your machine for use, 3 4 5, Please Note, brewing continues, the brew mechanism