Floor Level and Inner Roll Stop Adjustments
Inner Roll Stop Adjustment
Do not adjust inner roll stop linkage rod at this time! Link- age rod adjust-
ment is not required unless extra usable platform length is needed. If the
angle of the inner roll stop (when in the vertical position) restricts the usable platform length for the wheelchair passenger, adjustment of the linkage rod will change the angle.
With the platform at ground level and the inner roll stop in the vertical position, there should be a minimum of 1" clearance between the in- ner roll stop and torque tube. See Photo I.
Adjust the inner roll stop as detailed in the fol- lowing procedures. Then, adjust the linkage rod as detailed on page 10 (only if necessary).
1.Raise the lift platform fully (floor level) using the manual operation system (Manual Op- erating Instructions detailed on Quick Refer- ence Installation Sheet). If the inner roll stop rests properly on the floor, do not adjust the inner roll stop. Lower the platform to ground level. If the angle of the inner roll stop (when in the vertical position), does not restrict the usable platform length for the wheelchair passenger, disregard inner roll stop adjust- ment procedures. See Photo G on page 10. Refer to the following procedures if adjust- ment is required.
2.Position the lift platform ap- proximately 12" above stow level using the manual operation system. See Photo C.
Raising the platform will allow access to the cam securement screw and nut. See Photo E.
Inner Roll Stop
B |
Linkage Rod
Manual Operation Systems
VALVE | Hand | |||
Release |
|
|
| Pump |
|
|
| ||
Cable | N | C |
L | ||
| E | O |
| P | S |
| O | E |
|
|
| Pump |
|
Figure A | Handle | Valve |
Stow Level
Platform
12"
above
Stow
Level
C |
Page 8
