Maintenance and Lubrication Schedule

 

Inspect limit switches for securement and proper

Resecure, replace or adjust as needed. See

 

adjustment

Switch Adjustment.

 

Inspect carriage, lifting arm and eccentric shaft

Correct, replace damaged parts and/or relubricate.

 

rollers (bearings) for wear or damage, positive

 

 

securement and proper operation

 

 

Inspect external snap rings (e-clips):

Resecure, replace or correct as needed.

 

• Carriage roller bearings (4)

 

 

• Lower lifting arm pins (5)

 

 

• Upper lifting arm pins (2)

 

 

• Outer race bearings (2)

 

 

• Inner roll stop shaft (2)

 

 

Inspect lower lifting arm pins for wear or damage,

Resecure, replace damaged parts, lubricate or

1500

positive securement and proper adjustment

correct as needed.

 

 

Cycles

Inspect eccentric shaft pins, bearing mounting

Resecure, replace damaged parts, lubricate or

 

 

screw, washers and securement hardware for

correct as needed. See Carriage Ride Height

 

wear or damage, positive securement and proper

Adjustment.

 

operation

 

 

Inspect torque tube cams for securement, wear or

Resecure, replace or correct as needed.

 

damage

 

 

Inspect housing cam brackets for securement,

Resecure, replace or correct as needed.

 

wear or damage

 

 

Inspect cylinder(s), hoses, fittings and hydraulic

Tighten, repair or replace if needed.

 

connections for wear, damage or leaks

 

 

Inspect power cable

Resecure, repair or replace if needed.

 

 

 

4500

Cycles

Hydraulic Fluid (Pump) - Check level. Note: Fluid should be changed if there is visible contamina- tion. Inspect the hydraulic system (cylinder, hoses, fittings, seals, etc.) for leaks if fluid level is low.

Inspect lifting arm bushings and pivot pins for vis- ible wear or damage

Inspect outer barrier pivot pin mounting bolts (2)

Mounting

Decals and Antiskid

Use 5606 aviation fluid only (part 87010R). Check fluid level with platform lowered fully. Fill to within 1-1/2" of the bottom of the fill tube (neck).

Replace if needed.

Tighten or replace if needed

Check to see that the lift is securely anchored to the vehicle and there are no loose bolts, broken welds, or stress fractures.

Replace decals if worn, missing or illegible. Re- place antiskid if worn or missing.

Consecutive

750Cycle Intervals

Repeat all previously listed inspection, lubrica- tion and maintenance procedures at 750 cycle intervals.

Page 15

Page 17
Image 17
Braun NUVL855RM24 service manual Cycles