Braun NUVL855RM24 Floor Level and Inner Roll Stop Adjustments, Floor Level Switch Adjustment

Floor Level and Inner Roll Stop Adjustments

Achieving proper floor level positioning of the plat- form and inner roll stop requires a combination of Floor Level switch adjustment and inner roll stop adjustment. Both are factory set but must be in- spected during installation procedures (will vary per vehicle application).

Ensure the lift is positioned and secured as speci- fied on Quick Reference Installation Sheet (sup- plied with lift) panels 1 and 2. Adjust the Floor Level switch first (detailed below). Then, adjust the inner roll stop as detailed in Inner Roll Stop Adjustment Instructions (adjust only if necessary). The inner roll stop must rest properly on the vehicle floor for wheelchair entry and exit.

Note: Lift model NUVL855RM24 depicted in adjustment photos. Adjustment procedures are applicable for lift model NUVL855RM24.

Floor Level Switch Adjustment

Adjust the Floor Level switch first! (before adjusting the inner roll stop)!

The Floor Level switch stops upward travel of the platform during the Up function (activated by the torque tube-mounted Floor Level cam).

Position the bottom of the lift platform 1 1/2" above floor level (threshold mat) using the manual op- eration system. Do not operate the lift with the electric pump during adjustment procedures.

Loosen the clamp securing the torque tube-mount- ed Floor Level cam. Rotate the cam until the Floor Level switch is activated (cam depresses switch).

Note: Check the floor level position of the platform and the inner roll stop after powering the pump. Hydraulic pressure may affect platform height slightly. Fine tuning adjustment (tweaking) of the Floor Level switch may be required.

Floor Level Cam Floor Level Switch

A

Torque Tube Cam depressing switch.

Page 7