OPERATING INSTRUCTIONS cont.
OPERATING INSTRUCTIONS cont.
Food Chopper Assembly
Caution - Blades are sharp. Use extreme caution when handling the blade, always hold it by the plastic hub. Do not immerse the gear box in water.
1.Place blade support in the groove inside the glass beaker.
2.Insert the chopper blade onto the blade support.
3.Place the food to be chopped into the glass beaker.
4.Cover the glass beaker with the chopper gear box adapter.
5.Place the chopper gear box on top of the glass beaker.
6.Attach the power pack to the chopper gear box by rotating 90° counterclockwise and lining up the arrows.
7.If you wish to use the Frothier attachment to whip cream or milk, insert onto chopper blade as shown in illustration at right. The frothier attachment is NOT to be used for chopping.
Power Pack
Chopper Gear
Box
Chopper Gear
Box Adapter
Frothier
(not for chopping)
Chopper Blade
Blade Support
Using the Food Chopper
*Only process very soft, tender pieces of food.
*Food pieces should not be larger than
*Do not fill the processor bowls more than half way with very soft, tender foods like cooked apples or tomatoes. When pureeing foods like cooked vegetables, soft cheese, or cooked poultry, only add a few pieces at a time so that the unit does not jam. It is best to batch feed when using this appliance.
*Avoid pureeing foods like citrus fruits or other foods that have a lot of fiber or hard, tough skin which can jam the appliance.
*Should the unit jam during use and the blade stops turning, cease operation and unplug the unit from the power source. Disassemble the unit to remove any food that is jammed.
Caution: Never put your fingers or any utensils in the Stick Blender/Chopper during operation.
Warning: This appliance is designed
for intermittent use. Maximum running time with the Chopper is 15 seconds. Allow unit to cool before resuming use. Best chopping results are achieved by using
Important: To mince meat, cut the meat into 1/2” cubes and do not mince more than 6 oz. at one time. Make sure that the meat, fish or poultry is fully defrosted and that all bones and gristle have been removed. Allow cooked food to cool before placing in the chopping bowl.
1. After assembling the unit, hold the |
Press on the switch for 2 to 3 seconds and then let go. Repeat this procedure until the food has reached the desired consistency.
3.Disconnect the unit from the power source. After the blade has fully stopped, remove the chopper gear box and the chopper gear box adapter. Using a rubber spatula, remove the chopped or minced food from the glass beaker.
Caution: Never put your fingers or any utensils in the Stick Blender/Chopper during operation.
Crushing Ice
Caution - Blades are sharp. Use extreme caution when handling the blade, always hold it by the plastic hub. Do NOT immerse Power Pack in
water or any other liquid.
Ensure that the chopper gear box, chopper gear box adapter and blade assembly is well seated before turning the unit on to chop ice. Hold appliance with BOTH hands when chopping ice.
1.Assemble the chopper as you would for chopping (see page 5 for assembly instructions).
2.Place ice cubes to be crushed into bowl.
3.Hold the power pack firmly with one hand and pulse the On/Off switch with your index finger as you hold the
glass beaker firmly with the other when you are crushing ice cubes.
Note: Recommended size of ice cubes is 1 1/4” x 1” x 3/4”. Do not crush more than 6 oz. of ice cubes at a time.
Warning:This appliance is intended for
intermittent use. When crushing ice, use only bursts of 4 seconds each. Run time not to exceed 15 seconds before allowing unit to cool down.
Glass Beaker
power pack with your hand, press and |
hold down on the On/Off switch with |
your index finger. |
2. To avoid the food from being over |
processed, use the pulse method of |
chopping and mincing. |
Caution: Hold both the bowl/gear box and power pack when chopping ice. Don’t hold appliance by the power pack only.
5
6
