Breckwell P23FSL, P23I, P23FSA Installation, Figure Figure Figure, Freestanding, Fireplace Insert

INSTALLATION

5

SPECIFICATIONS

FREESTANDING:

Width: 22 ½”

Height: 29” (with pedestal), 28 ½” (with legs)

Depth: 27” (excluding ash lip)

Weight: 210 lbs.

Pedestal: 40 lbs.

Legs: 13 lbs.

Flue size: 3” or 4”

Hopper Capacity: Up to 60 lbs.

(this can vary widely depending on pellet size, length, and diameter) EPA status: exempt

Burn time: 1 lb. to 5 lbs. per hour

BTU range: 8,200 to 47,000

Approved installations: mobile home, alcove, conventional

FIREPLACE INSERT:

Width: 21” (With flashing: 42”)

Height: 20” (With flashing: 30” or 32”)

(depending on which size of flashing used) Depth: 22 ¾”

In fireplace: 11 ½”

Weight: 185 lbs.

Flashing: 13 lbs.

Flue size: 3” or 4”

Hopper Capacity: Up to 60 lbs.

(this can vary widely depending on pellet size, length, and diameter) EPA status: exempt

Burn time: 1 lb. to 5 lbs. per hour

BTU range: 8,200 to 47,000

Approved installations: zero-clearance, masonry, as a built-in

PREPARATION

Factory packaging must be removed, and some minor assembly work is required prior to installation. Access to the rear of the stove is necessary.

The circuit board/control panel must be unpacked and installed in the side flashing on the insert. (See installation instructions provided with the circuit board)

NOTE: Normally, your dealer will perform these functions.

CLEARANCES

The Breckwell P23 Freestanding has been tested and listed for installation in residential, mobile home and alcove applications.

The P23 Insert is approved for installation into code complying masonry fireplaces.

The P23 Insert is also approved for use in listed factory built fireplaces (UL 127) and standard residential built-ins (see As A Built-In Fireplace), including Mobile Home built-in installations, of the following description: all brands at least 33” wide and 20 ½” high.

FLOOR PROTECTION: Freestanding installations, minimum 22” wide by 31” deep. The stove must be placed on a continuous (grouted joints) noncombustible material such as ceramic tile, cement board, brick, 3/8” millboard or equivalent, or other approved or listed material suited for floor protection. NOTE: ceramic tile, or any tile, requires a continuous sheet beneath to prevent the possibility of embers falling through to the combustible floor if cracks or separation should occur in the finished surface, this would include floor protection for Built-in raised hearths. Check local codes for approved alternatives.

Clearances are measured from the sides, back and face (door opening) or stove body (refer to fig. 4).

DO NOT USE MAKESHIFT MATERIALS OR COMPROMISES IN THE INSTALLATION OF THIS UNIT.

INSTALL VENT WITH CLEARANCES SPECIFIED BY THE VENT MANUFACTURER.

FIGURE 1

FIGURE 2

FIGURE 3

FLOOR PROTECTION

FIGURE 4