PAGEOPERATINGHEADER.....
BEFORE FIRST USE
Machine Preparation
Remove and discard all labeling and packaging materials attached to your espresso machine. Ensure you have removed all parts and accessories before discarding the packaging.
Remove the water tank located at the back of the machine by lifting the water tank handle. Remove the plastic bag containing the water filter and water filter holder. Clean parts and accessories (water tank, portafilter, filter baskets, milk jug) using warm water and a gentle dish washing liquid, then rinse and dry thoroughly. Wipe the outer housing and drip tray with a soft damp cloth and dry thoroughly. Do not immerse the outer housing, power cord or power plug in water or any other liquid.
NOTE
Do not use abrasive cleansers, pads or cloths which can scratch the surface. Do not clean any of the parts or accessories in the dishwasher.
CONDITIONING THE WATER FILTER
•Remove the water filter and water filter holder from the plastic bag.
•Soak the water fiilter in a cup of water for 5 minutes, then rinse under cold running water.
•Wash the water fiilter holder with cold water, taking specifiic care to rinse the stainless steel mesh.
•Insert the water fiilter into the two parts of the water fiilter holder.
•Set Date Dial 2 months ahead.
•To install the assembled water fiilter holder into the water tank, align the base of the water fiilter holder with the adapter inside the water tank. Push down to lock into place.
•Slide the water tank back into position at the back of the machine, ensuring to push down completely to lock into place.
NOTE
To purchase water filters contact Breville Consumer Support.
PAGEOPERATINGHEADER.....
FIRST USE
Initial Start Up
•Ensure the water filter is securely fitted inside the water tank.
•Fill the water tank with cold, preferably filtered water up to the MAX mark. When replacing the water tank, ensure to push down completely to lock into place.
NOTE
Always check the water level before use and replace water daily. Use cold, preferably filtered water. Do not use demineralized or distilled water or any other liquid.
• Plug the power cord into a 110/120V |
power outlet. |
• Press the POWER button to switch the |
machine On. The POWER button light |
will flash while the machine is heating. |
• A pumping sound will be heard. This is |
normal. |
• When the machine has reached the |
correct operating temperature, the |
POWER button light will stop flashing |
2.Rotate the STEAM/HOT WATER dial to the HOT WATER position and run for 10 seconds.
Repeat this cycle until the water tank is empty.
STEAM | STANDBY | HOT WATER |
GENERAL OPERATION
Preset Shot Volume - 1 CUP button
Press the 1 CUP button once to extract a single shot of espresso at the preset volume (approx. 1oz / 30ml). The extraction will start using the low pressure
1 | 2 | 3 | 4 | 5 | 6 |
|
|
| REPLACEMENT DUE |
|
|
Soak water filter for 5 mins | Rinse water filter & mesh | Place filter into filter holder | Set date 2 months ahead | Install filter in water tank | Insert & lock water tank |
and all button lights on the control panel |
will illuminate. The machine is now in |
STANDBY mode, ready for the next step |
‘Flushing The Machine’. |
Flushing the Machine
It is recommended to complete a water flushing operation, without ground coffee, to ensure the machine has been conditioned.
When the machine has reached STANDBY mode, run the following 2 steps:
1.Press 1 CUP button to run hot water through the group head.
NOTE
The amount of espresso extracted in the cup will vary depending on your grind size and dose amount.
12 |
| 13 |
|
|
|
