Breville BFP250 manual Assembly and operation of your, Breville Wizz Multi Processor continued

Assembly and operation of your

Breville Wizz™ Multi Processor continued

Using the stainless steel slicing/ shredding discs

1.	Place the disc holder spindle onto the shaft
	in the processing bowl.
2.	Fit disc onto disc holder by placing the wider
	lug on end of disc, into one side of the disc
	holder opening (Fig 3). Lower the disc down
	over shaft hole then push disc down to lock
	into position (Fig 4). To remove disc, hold disc	Fig.3
	holder with the disc facing away and place
	thumbs underneath the end of disc marked
	‘Push Up’ and push out (Fig 5).
3.	Place the disc holder onto the disc holder
	spindle.

Fig.4

Fig.5

WARNING: WHEN SLICING AND SHREDDING, ALWAYS USE THE FOOD PUSHER TO GUIDE FOOD DOWN THE FOOD CHUTE. NEVER PUT YOUR FINGERS OR SPATULA INTO THE FOOD CHUTE. ALWAYS WAIT FOR THE DISC TO STOP SPINNING BEFORE REMOVING THE LID.

THE PROCESSING BLADE AND THE DISCS ARE EXTREMELY SHARP!! USE CAUTION WHEN HANDLING AND STORING THESE PARTS.

Assembly and operation of your Breville Wizz™ Multi Processor continued

Using the stainless steel processing blade

1.Carefully remove the protective storage cover from the processing blade.

2.Place the processing blade over the drive shaft (see Fig 6). Rotate it slowly until

it settles into place. When handling the processing blade, always hold by the spindle

(as shown in Fig 7). Fig.6

3.Place the food to be processed into the processing bowl as indicated in the recipe.

To avoid over-processing, check the consistency frequently when the food being processed requires a coarse or thick texture. If necessary, turn the Speed Selection Dial to the Off ‘O’ position, switch off at the power outlet, unlock the lid and use the spatula to scrape down the sides of the bowl to ensure even processing.

Fig.7

Care should be taken when removing the food from the processing bowl by ensuring the motor and the processing blade or disc, have completely stopped before disassembling. Ensure the Speed Selection Dial is turned to the Off ‘O’ position, the appliance is switched off at the power outlet and unplugged, before removing the lid from the bowl. The processing bowl should then be unlocked from the motor body and the processing blade or disc holder carefully removed before attempting to remove the processed food.