Breville BLR50 Operating Your Breville Power Blender, Before first use, Disassembling the blender

Operating Your Breville Power Blender

Before first use

Remove and safely discard any packaging material and promotional labels.

Disassemble the blender jug by following the steps in the ‘Disassembling the blender’ section below. Wash the lid, inner lid, blender jug, silicon seal, blender jug base and blade assembly in warm, soapy water with a soft cloth. Rinse and dry thoroughly.

Wipe the motor base with a damp cloth and dry thoroughly.

Disassembling the blender

1.Place the motor base on a flat, dry surface such as a bench top. Ensure that the speed selection dial is in the off ‘0’ position, the appliance is switched off at the power outlet and the power cord is unplugged.

2.Remove the blender jug from the motor base by holding the motor base firmly and grasping the blender jug handle and pulling the blender jug up and off the motor base.

3.Remove the lid and inner measuring cup from the blender jug.

4.Place the jug upside down on a flat, dry surface such as a bench top.

5.Hold the jug handle and turn the blender jug base anti-clockwise to remove. Carefully lift the blade assembly out of the narrow end of the blender jug. Remove the silicon seal from outside the narrow end of the blender jug.

NOTE

The blending blades are extremely sharp. Avoid any contact with fingers and hands.

	7
BLR50_IB_Issue1,10_FA.indd 7	9/12/09	2:56 PM