PowerBOSS™ | 5000W Portable Generator | ASSEMBLY |
|
|
|
ASSEMBLY
Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.
If you have any problems with the assembly of your generator, please call the generator helpline at
Remove Generator From Carton
1.Set the carton on a rigid flat surface with “This Side Up” arrows pointing upward.
2.Carefully open the top flaps of the shipping carton.
3.Cut down corners at one end of carton from top to bottom and lay that side of carton down flat.
4.Remove all packing material, carton fillers, etc.
5.Remove the generator from the shipping carton.
•Engine manual
•Wheel kit
If any parts are missing or damaged, call the generator helpline at
INSTALL WHEEL KIT
NOTE: While the wheel kit is designed to greatly improve the portability of your generator, it is not intended for
You will need two 1/2” or 13mm open end wrenches or a socket wrench with 1/2" or 13mm sockets and a 15/16” wrench to install this kit.
Install the wheel kit as follows (Figure 1):
1.Place bottom of generator cradle on a flat surface.
2.Place axle stud through wheel retainer on cradle frame.
3.Use 15/16” wrench to secure axle stud to frame with
Carton Contents
Check all contents against those listed below:
•Main unit
•Engine oil
•Owner’s manual
4.Install other axle stud in same manner.
NOTE: Be sure to install wheel with raised hub inboard.
5.Tip unit and install wheel. Place flat washer over axle stud.
Figure 1 — Install Wheel Kit
Typical Generator Shown |
|
|
|
Capscrew |
|
|
|
Nut |
|
| Jam Nut |
|
|
| |
Handle |
|
| Washer |
|
|
| |
| Axle |
| |
| Stud |
| |
Mounting Leg | Capscrew | Wheel | Retaining Pin |
| |||
|
|
| |
Nut |
|
|
|
| 6 |
|
|