Briggs & Stratton Power Products Home Generator System
Owners Manual
GENERATOR
•Slide the oil drain tube up into the clamp on the generator.
MAINTENANCE
The generator warranty does not cover items that have been subjected to operator abuse or negligence.To receive full value from the warranty, the operator must maintain the system as instructed in the engine owner’s manual.
All adjustments should be made at least once each season. Follow the requirements in the engine owner’s manual.
Generator maintenance consists of keeping the unit clean and dry. Operate the unit in an environment where it will not be exposed to excessive dust, dirt, moisture or any corrosive vapors. Cooling air louvers on the enclosure must not become clogged with snow, leaves, or any other foreign material.
Check the cleanliness of the unit frequently and clean when dust, dirt, oil, moisture or other foreign substances are visible on its exterior surface.
NOTE: Do Not use direct spray from a garden hose to clean generator.Water can enter the engine and cause problems. In addition, if water enters the generator through cooling air slots, some water will be retained in voids and cracks may develop in the rotor and stator winding insulation.Water and dirt buildup on the generator internal windings will eventually decrease the insulation resistance of these windings.
Changing Engine Oil
•Place the oil drain tube into an approved container.
•Push in and rotate the oil drain fitting 1/4 turn counterclockwise. Slowly pull outward until oil starts draining (Figure 6). DO NOT pull the oil drain fitting off the engine.
Figure 6 — Oil Drain Fitting
•When the oil has drained, push the oil drain fitting in and rotate 1/4 turn clockwise until it locks in place.
CAUTION! Any attempt to crank or start the engine before it has been properly filled with the recommended oil will result in engine failure.
To fill your engine with oil:
•Follow the synthetic oil grade recommendation and oil fill instructions given in the engine owner’s manual.
To Clean the Generator
CAUTION! NEVER insert any object or tool through the air cooling slots, even if the engine is not running.
•Use a damp cloth to wipe exterior surfaces clean.
•A soft, bristle brush may be used to loosen caked on dirt, oil, etc.
•A vacuum cleaner may be used to pick up loose dirt and debris.
•Low pressure air (not to exceed 25 psi) may be used to blow away dirt. Inspect cooling air slots and openings on the generator.These openings must be kept clean and unobstructed.
If You Call the Factory
You must have the following information at hand if it is necessary to contact Briggs and Stratton Technical Services regarding service or repair of this unit:
1.Obtain the unit Model Number and Serial Number from the unit data decal. See “Know Your Backup Generator” diagram for location.
2.Obtain the engine Model/Type/Code numbers from the engine label. See “Know Your Backup Generator” diagram for location. Please note that the model number may vary slightly from that presented herein.
STORAGE
The Briggs & Stratton Home Generator System is designed for continuous backup operational duty. As such, there is no need to take any storage precautions. However, if it becomes necessary to take the system out of service for an extended period, call Briggs and Stratton Technical Services at
18
