Briggs & Stratton 1687286, 1687302 installation instructions Installation Instructions

Installation Instructions Power Steering Conversion Kit

19.Install new axle (A, Figure 11) between axle support plate (B) and frame (C) using a 5/8-11 x 3-1/2 cap- screw (D), two 5/8 flat washers (E), and a 5/8-11 flange nut (F) as shown. Tighten flange nut to 150 ft. lbs (204 Nm).

22.Tighten all four 3/8-16 support plate bolts (E, Figure 2) to 19.5 Ft. lbs (26.5 Nm

	C
	B
D	D
	C
	C
	A

Figure 11 New Axle Installation

A.New Axle

B.Axle support Plate

C.Frame

D.Capscrew, 5/8-11 x 3-1/2

E.Flat Washers, 5/8

F.Flange Nut, 5/8-11

21.Install heat shield (A, Figure 12) using four 1/4-20 Whiz Lock screws (B) as shown.

Tighten screws to 10 ft. lbs (13.6 Nm).

NOTE: Replace any speed nuts (E) broken or missing from heat shield with parts from kit.

22.Install bumper (C, Figure 12) using four 5/16-18 x 7/8 Torx screws (D) as shown.

Tighten screws to 7 ft. lbs (9.75 Nm).

NOTE: Replace any speed nuts (F) broken or missing from bumper mounts with parts from kit.

	B
	D
	F
	B
D	C
	A
	E

Figure 12 Bumper and Heat Shield Installation

A.Heat Shield

B.Whiz Lock Screws, 1/4-20

C.Bumper

D.Torx Head Screw, 5/16-18 x 7/8

E.Speed Nut, 1/4-20

F.Speed Nut, 5/16-18

2-6