Installation Instructions | Power Steering Conversion Kit |
NOTE: For initial installation, only two screws are used (as shown) and the screws are to be loosely installed to allow the tower to pivot.
3.Attach new tower assembly (A, Figure 15) to frame
(A) using two
4.Install control valve spool and support (B, Figure 16) to the new tower (A) using (previously removed) four
Tighten lock nuts to 7 ft. lbs (9.75 Nm).
C |
A |
C |
B |
Figure 15 Tower Assembly Installation
A.New Tower Assembly
B.Frame
C.Taptite Screws, 3/8-16 x 3/4
B |
A |
D |
C |
Figure 16 Control Valve Spool & Support Installation
A.New Tower Assembly
B.Control Valve Spool & Support
