BSPP 1950 PSI Pressure Washer

2.Point nozzle towards a firm surface and press trigger to test spray pattern (Figure 10).

Figure 10 — Testing the Spray Pattern

Applying Detergent With Adjustable NozzleIMPORTANT: Use soaps designed specifically for

pressure washers. Household detergents could damage the pump.

CAUTION

You must attach all hoses before you start the engine.

•Starting the engine without all the hoses connected and without the water turned ON will damage the pump.

•Damage to equipment resulting from failure to follow this instruction will void warranty.

3.Twisting nozzle adjusts spray pattern from a narrow pattern to a fan pattern (Figure 11).

Figure 11 — Adjusting the Nozzle for Spray Pattern

Clockwise = Narrow Spray

Counterclockwise = Fan

Pattern

Spray Pattern

 

 

Usage Tips

•For most effective cleaning, keep spray nozzle from 8 to 24 inches away from cleaning surface.

•If you get spray nozzle too close, especially using high pressure mode, you may damage surface being cleaned.

•DO NOT get closer than 6 inches when cleaning tires.

To apply detergent, follow these steps:

1.Review adjustable nozzle use.

2.Prepare detergent solution as required by job.

3.Place filter end of chemical injection hose into detergent container.

CAUTION

Keep the chemical injection tube from coming in contact with the hot exhaust.

•When inserting the filter into a detergent solution bottle, route the tube so as to keep it from inadvertently contacting the hot exhaust.

4.Slide adjustable nozzle forward to low pressure mode. Detergent cannot be applied with nozzle in high pressure position.

5.Make sure garden hose is connected to water inlet. Check that high pressure hose is connected to spray gun and pump; start engine.

6.Apply detergent to a dry surface, starting at lower portion of area to be washed and work upward, using long, even, overlapping strokes.

7.Allow detergent to "soak in" for 3-5 minutes before washing and rinsing. Reapply as needed to prevent surface from drying. DO NOT allow detergent to dry on (prevents streaking).

IMPORTANT: You must flush the chemical injection system after each use by placing the filter into a bucket of clean water, then run the pressure washer in low pressure for 1-2 minutes.

10