BSPP 1950 PSI Pressure Washer
Pressure Washer Rinsing
For Rinsing:1.Slide nozzle backward to high pressure, press trigger and wait for detergent to clear.
NOTE: You can also stop detergent from flowing by simply removing chemical injection hose from bottle.
2.Keep spray gun a safe distance from surface.
WARNING
High pressure spray could cause you to fall if you are too close to the cleaning surface.
•Keep spray nozzle between 8 to 24 inches away from cleaning surface.
•Operate this unit on a stable surface.
•Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location.
•Firmly grasp spray gun with both hands when using high pressure spray to avoid injury if gun kicks back.
3.Apply high pressure spray to a small area, then check surface for damage. If no damage is found, it is okay to continue cleaning.
4.Start at top of area to be rinsed, working down with same overlapping strokes as used for washing and applying detergent.
Cleaning Chemical Injection Hose
If you used the chemical injection hose, you must flush it with clean water before stopping the engine.
1.Place chemical injection hose in a bucket full of clean water.
2.Slide adjustable nozzle forward to low pressure position. Flush for
3.Shut off engine.
IMPORTANT: Simply shutting OFF engine will not release pressure in the system. When the engine has
shut down, squeeze the trigger on the spray gun to relieve the pressure in the hose.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
11