Assembly

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at 1-800-743-4115. If calling for assistance, please have the model, revision, and serial number from the data tag available. See Generator Controls and Features for data tag location.

Unpack Generator

1.Set the carton on a rigid, flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use.

You will need the following tools to install these components:

•3/8” and 13 mm wrench

•Socket wrench with a 3/8” and 13 mm socket

•Pliers

•Safety glasses

Install the wheel kit as follows:

1.Tip generator so that engine side is down.

2.Slide axle (A) through both mounting brackets.

3.Slide a wheel (B) over axle.

NOTE: Be sure to install wheel with raised hub inboard.

4.Place a washer (C) on axle and then place an e-ring (D) in axle groove.

Shipment Contents

The generator is supplied with:

•Engine oil

•Operator’s manual

•Battery float charger

CAUTION

E-rings can cause eye injury.

E-rings can spring back and become airborne when installing or removing.

• Always wear eye protection when installing/removing e-rings.

•Battery charge cables

•Wheel kit

•120/240 Volt, 30 Amp locking plug

•120 Volt, 30 Amp locking plug

5.Install e-ring with pliers, squeezing from top of e-ring to bottom of axle.

6.Repeat steps 3 through 5 to secure second wheel.

N

K

M

 

 

J

 

L

 

H

F

E

G

A

B

C

D

7