Briggs & Stratton 30238 owner manual Assembly, Install Wheel Kit, Remove Generator From Carton

ASSEMBLY

ASSEMBLY

Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your generator, please call the generator helpline at

1-800-743-4115. If calling for assistance, please have the model, revision, and serial number from the data tag available.

Install Wheel Kit

NOTE: Wheel kit is not intended for over-the-road use. You will need the following tools to install these components:

•1/2" or 13mm wrench

•Socket wrench with a 1/2" or 13mm socket

•Pliers

Refer to Figure 1 and install the wheel kit as follows:

Remove Generator From Carton

1.Set the carton on a rigid flat surface.

2.Remove everything from carton except generator.

3.Open carton completely by cutting each corner from top to bottom.

4.Leave generator on carton to install wheel kit.

1.Tip generator so that engine end is up.

2.Slide axle through both mounting brackets.

3.Place a wheel on each side with air valve facing out.

4.Place a washer on axle and then place an e-ring in axle groove.

5.Install e-ring with pliers, squeezing from top of e-ring to bottom of axle.

Figure 1 — Install Wheel Kit

Cap Screw
Hex Nut
Handle Assembly		Flat Washer
	Axle
Support Leg	Cap Screw
Hex Nut	Wheel	E-Ring

6