ASSEMBLY
STEP 3:
A
Slide Engine Mount Arm (B) into the receiver on the Mount Plate (A) and fasten by dropping in ball pin (#J0248). Place Engine/ Blower Assembly onto Engine Mount Arm (B) and fasten with (4)
STEP 4:
The ears of the Cone (A) should fit underneath the two threaded bosses on the Blower Face (B). Secure with (2)
TIGHTEN CONE BOLTS BEFORE EACH USE! | B |
|
B
A
Impeller Blade Replacement
To remove: Remove hex bolts from hub then screw the bolts
into threaded holes to remove old blade. | B |
(This will push the impeller off the hub.) If the | A |
impeller is stuck on, hit the base of the impeller between each vein with a hammer then try the bolts again.
To replace: Place tapered bushing (A) into hub (B) and align
Secure with two 1/4" x 1" hex bolts. Torque to 15 ft. lbs.
MODEL 37641401 - 04 | PeCo 5 |