Contour Pellet Stove
Exhaust Blower Replacement Instructions
Part #812-4400
Included in Kit: (1) Blower; (1) Gasket
FIG.1
CONTOUR SHOWN WITH TOP REAR SCREEN AND VACUUM SWITCH
REMOVED.Exhaust
Blower
Remove
wires from
Blower
Lower Rear Screen
1. Unplug stove.
2.Remove both side curtains by opening halfway, then lifting up and pulling back.
3.Disconnect vacuum hose and both wires (orange and red) from the vacuum switch so you can remove the top rear screen.
4.Unscrew and remove top rear screen.
5.Unscrew lower rear screen, and lay it on it's back as shown in Fig. 1.
Tools Required: Phillips Screwdriver; Flathead Screwdriver or 1/4" Nutdriver.
FIG. 2
6.Remove both wires from exhaust blower (blue and double white).
7.Remove 6 screws using a flathead screwdriver or a 1/4" nutdriver. Retain screws for use on replacement blower. See Fig 2.
8.Remove exhaust blower and gasket.
9.Install new gasket and blower by reversing steps
FEED MOTOR Replacement Instructions
Part #812-4420 Feed motor
FIG. 1
FIG. 2
Molex Connectors
Feed Motor Mount Screws |
mounting
Auger shaft set screw
Rectangular nylon bearing
1.UNPLUG THE STOVE.
2.Open the right Side Curtain to expose the Feed Motor.
3.Disconnect the Molex connectors. Remove the two screws from the Feed Motor Mount. (Figure 1)
4.Pull the Feed Motor/Auger assembly straight out towards you, being careful not to hit the Control Box.
5.Loosen set screw that secures Auger Shaft to Feed Motor Shaft. (See Figure 2), Remove 4 screws attaching Feed Motor to mount. Lift off old motor and replace with new. Secure with screws. Ensure Auger Shaft set screw aligns with flat side of Feed Motor Shaft.
6.
October 10, 2001 | 24 |