Contour Pellet Stove
TRIM RING INSTALLATION INSTRUCTIONS
Part #811-0820
Kit Contents: Trim Ring (1); | Grille |
Tools Required: Phillips head screwdriver; 11/32" wrench or nut driver; small screwdriver or punch.
FIG. 1
NOTE: Front Face and Door can be removed from stove while attached together, or you may leave the Door on the hinges while you remove the Front Face from the Door.
Rib
Face
1 If leaving the Door on the hinges, hold the Front Face
Rib
in place while removing the screws from Grille so that it |
|
does not fall forward and potentially become damaged. |
|
Remove Grille and set aside. See Fig. 1 | Locating Screws |
| (on rib, the two |
| Door |
FIG. 2
2. Tilt the top of the Front Face forward until the top rib |
|
clears the door, then slide the face down until the locat- |
|
ing screws on the bottom rib are completely out of the |
|
door. |
|
See Fig. 2 |
|
3. |
|
Lay Front Face on protective surface, face side down |
|
Use a small screwdriver or punch to push filler buttons |
|
out. See Fig. 3 |
|
NOTE: The holding tabs on the back side of the but- |
|
tons have been bent over to secure for shipping. |
|
You must bend the tabs back up to remove the but- |
|
tons. | FIG. 3 |
4
Locating Screws (on rib, the two
October 10, 2001 | 22 |