Quadra-Fire QUADRA-FIRE CONTOUR warranty Top Vent Flue Adapter Installation, Feed Adjustment

Contour Pellet Stove

TOP VENT FLUE ADAPTER INSTALLATION

Part #811-0860, 3"-3" Top Vent Adapter or Part #812-3570, 3"-6" Offset Collar

1)Put a layer of silicone on the 3" (76mm) exhaust outlet.

2)Slide the flue adapter onto the rear exhaust outlet.

3)Adjust the assembly to a vertical position.

4)Drill four holes with #26 drill bit (provided) into the back of the stove using the outer shield as a pattern (make sure the assembly is vertical).

5)Install the four mounting screws.

6)Drill two holes with #26 drill bit through the Rear Exhaust Outlet using the two holes already in the short horizontal pipe in the Top Vent Adapter as a guide. Install the two screws

7)Install the stove pipe into the adapter (be sure to silicone all joints).

8)To clean adapter, remove cleanout cover.

Use hole on each

side as drilling guide

Rear Exhaust

Outlet

FEED ADJUSTMENT

Mount with four screws

NOTES:

The feed adjustment rod is factory set, and should be adequate for most fuels. However, if the flame height is too high or too low, follow the instructions below.

Loosen the set screw (Fig. 1) 1/4 to 1/2 turn during set-up of stove. This will allow movement of the Fuel Adjustment Rod. Do not re-tighten set screw.

Adjust fuel adjustment rod after the stove has been burning for 10-15 minutes. The flames should be approximately 4"(102mm) above the firepot at high heat output setting.

Cleanout Cover

1)Loosen the wing nut.

2)Adjust the fuel adjustment rod upward towards the "+" symbol, to increase the feed rate and flame height, or down towards the "-" symbol, to decrease the feed rate and flame height.

3)Re-tighten the wing nut.

FIGURE 1 FIGURE 2

Fuel Adjustment Rod

Wing Nut

October 10, 2001 9 250-5583