Xantrex Technology Freedom SW 2000 user service Installation Tools and Materials

Installation Tools and Materials

Tools

You will need the following tools to install the Freedom SW 2000 and the battery temperature sensor.

❐Wire stripper

❐Crimping tools for fastening lugs and terminals on DC cables

❐Phillips screwdriver: #2

❐Slot screwdriver (1/4" wide blade max.)

❐Needle-nose pliers

❐Wrench for DC terminals: 9/16"

Planning the Installation

Materials

You will need the following materials to complete your installation:

❐	Strain-relief clamp(s) for AC cables (not provided): 1"	only.
❐ DC battery cables sized according to Table 3 on page 11		installers
❐	Terminals and/or crimp connectors for DC cables (for 5/16" DC stud
	size on the Freedom SW 2000 inverter while the battery/fuse cable end
	may require larger size such as 3/8")	qualified
❐	Copper wire for DC grounding: No. 8 AWG. See “DC Grounding” on
	page 11
❐ Terminal or crimp connector for DC grounding cable (for 1/4" stud		by
	size)
		use
❐	AC and DC disconnect switches and over-current protective devices
		for
	and connectors as required. See page 10.
		guide
❐	AC output and input wire.
❐ Six 1/4"–20 1.25" length steel screws or bolts to mount the Freedom		This
	SW 2000

975-0527-01-01 13