Installing the Inverter/Charger
Step 4: Connecting the DC Cables
DC Connection Precautions
ELECTRICAL SHOCK HAZARD
Connect and disconnect DC wiring only after opening the disconnect switches or breakers at all AC and DC sources.
Failure to follow these instructions will result in death or serious injury.
Recommended Cable Sizes and Lengths and Fuse Size
For recommended DC cables and fuse size, see Table 3 on page 11.
Preparing the Cables
To prepare the DC cables:
1.Cut the negative and positive cables to the required length. Strip off enough insulation so you can install the terminals you will be using.
Xantrex recommends the use of crimp connectors. The connector should be designed for a 5/16" DC stud size on the Freedom SW 2000 inverter, while battery/fuse cable end may require a larger size such as 3/8" to connect to the Freedom SW 2000. If a crimp connector is used, it should be crimped using the tool indicated by the connector manufacturer.
2.Cut the DC ground cable to the required length. Strip off enough insulation so you can install the terminals you will be using.
Xantrex recommends the use of crimp connectors. The connector should be designed for a 1/4" stud size to connect to the Freedom SW 2000. If a crimp connector is used, it should be crimped using the tool indicated by the connector manufacturer.
3.Attach the connectors to the ends of both cables. Make sure no stray wire strands protrude from the connectors.
24 | Freedom SW 2000 Installation Guide |
