Alto-Shaam 1200-SK/III, 1000-TH/III dANgER, i n s t a l l a t i o n, E L Ect R Ical Connection

i n s t a l l a t i o n

E L ECT R ICAL CONNECTION

The appliance must be installed by a qualified service technician. The oven must be properly grounded in accordance with the National Electrical Code and applicable local codes.

Plug the unit into a properly grounded receptacle ONLY, positioning the unit so that the plug is easily accessible in case of an emergency. Arcing will occur when connecting or disconnecting the unit unless all controls are in the “off” position.

Proper receptacle or outlet configuration or permanent wiring for this unit must be installed by a licensed electrician in accordance with applicable local electrical codes.

dANgER

To avoid electrical shock, this appliance MUST be adequately grounded in accordance with local electrical codes or, in the absence of local codes, with the current edition of the National Electrical Code ANSi/ NfPA No. 70. in Canada, all electrical connections are to be made in accordance with CSA C22.1, Canadian Electrical Code Part 1 or local codes.

dANgER

ENSURE POWER SOURCE

MATCHES VOLTAGE iDENTifiED

ON APPLiANCE RATiNG TAG.

REGARDING INTERNATIONAL STANDARD UNITS:

If the unit is not equipped with flexible cord and plug, an all-pole country approved disconnection device which has a contact separation of at least 3mm in all poles must be incorporated in the fixed wiring for disconnection. When using a cord without a plug, the green/yellow conductor shall be connected to the terminal which is marked with the ground symbol. If a plug is used, the socket outlet must be easily accessible. If the power cord needs replacement, use a similar one obtained from the distributor.

for Ce approved units: To prevent an electrical shock hazard between the appliance and other appliances or metal parts in close vicinity, an equalization-bonding stud is provided. An equalization bonding lead must be connected to this stud and the other appliances / metal parts to provide sufficient protection against potential difference. The terminal is marked with the following symbol.

Hard wired models:

Hard wired models must be equipped with a country certified external allpole disconnection switch with sufficient contact separation.

If a power cord is used for the connection of the product an oil resistant cord like H05RN or H07RN or equivalent must be used.

NOTE: Where local codes and CE regulatory requirements apply, appliances must be connected to an electrical circuit that is protected by an external GFCI outlet.

dANgER

APPLiANCES WiTH NO CORD

PROViDED bY fACTORY MUST

bE EQUiPPED WiTH A CORD Of

SUffiCiENT LENGTH TO PERMiT

THE APPLiANCE TO bE MOVED

fOR CLEANiNG.

ELECTRiCAL CONNECTiONS MUST

bE MADE bY A QUALifiED SERViCE

TECHNiCiAN iN ACCORDANCE WiTH

APPLiCAbLE ELECTRiCAL CODES.

MN-29758 (Rev. 4) • TH/III & SK/III installation/operation/service manual pg. 13