INSTALLATION
9
• LP conversion kit
• Roof hardware bag
Lifting the Generator
CAUTION!The generator weighs more than 280 pounds.
Proper tools,equipment and qualified personnel should be
used in all phases of handling and moving generator.
CAUTION! DO NOTlift unit by roof as damage to
generator will occur.
Lifting pockets are provided at each corner between the
base of the generator and its mounting pad.Retouch any
chipped paint with supplied touch-up paint.
Home Generator System Location
Before installing generator,consult with homeowner and
convey the following guidelines which may affect the
desired location.
Generator Clearances
Place generator in a well ventilated area,which will allow for
removal of deadly exhaust gas.DO NOT install generator
where exhaust gas could accumulate and enter inside or be
drawn into a potentially occupied building.Ensure exhaust gas
is kept away from any windows,doors,ventilation intakes or
other openings that can allow exhaust gas to collect in a
confined area (Figure 1).Prevailing winds and air currents
should be taken into consideration when positioning generator.
General Location Guidelines
• Install the unit outdoors ONLY.
• Place the unit in a prepared location that is flat and has
provisions for water drainage.
• Install the unit in a location where sump pump discharge,
rain gutter down spouts,roof run-off, landscape irrigation,
or water sprinklers will not flood the unit or spray the
enclosure and enter any air inlet or outlet openings.
• Install the unit where the location of any services such as
phone,electrical, fuel, air conditioning,irrigation, including
covered,concealed and underground services will not be
affected or obstructed.
• Install the unit where air inlet and outlet openings will
not become obstructed by leaves,grass, snow,etc. If
prevailing winds will cause blowing or drifting,you may
need to construct a windbreak to protect the unit.
• Install the generator as close as possible to the Transfer
Switch to reduce the length of wiring and conduit.
• Install the generator as close as possible to the fuel
supply to reduce length of pipes.
IMPORTANT:Laws or local codes may regulate the
distance to the fuel supply.
The Home Generator System is shipped already attached
to its mounting pad.Unless mandated by local code, a
concrete slab is not required.
If mandated by local code,construct a concrete slab at least
3inches thick and 6 inches longer and wider than the unit.
Attach unit to slab with 1/4” diameter (minimum) masonry
anchor bolts long enough to retain the unit.
Figure 1 — Home Generator System Clearances
Exhaust
Port
• Operate generator ONLY outdoors.
• Keep exhaust gas from entering a confined area through
windows,doors, ventilation intakes or other openings.
Running generator gives off carbon monoxide,
an odorless,colorless, poison gas.
Breathing carbon monoxide will cause nausea,
fainting or death.
WARNING
• Keep at least 5 ft.(152 cm) clearance on all sides of generator
including overhead.
Exhaust heat/gases can ignite combustibles or
structures causing a fire.
WARNING