Briggs & Stratton 30A NEMA 1, 71017 manual Important Safety Instructions

IMPORTANT SAFETY INSTRUCTIONS

SAVE THESE INSTRUCTIONS

IMPORTANT SAFETY

INSTRUCTIONS

This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to avoid possible injury or death.

The safety alert symbol () is used with a signal word (DANGER, CAUTION, WARNING), a pictorial and/or a safety message to alert you to hazards. DANGER indicates a hazard which, if not avoided, will result in death or serious injury. WARNING indicates a hazard which, if not avoided, could result in death or serious injury. CAUTION indicates a hazard which, if not avoided, might result in minor or moderate injury. NOTICE, when used without the alert symbol, indicates a situation that could result in equipment damage. Follow safety messages to avoid or reduce the risk of injury or death.

The manufacturer cannot possibly anticipate every possible circumstance that might involve a hazard. The warnings in this manual, and the tags and decals affixed to the unit are, therefore, not all-inclusive. If you use a procedure, work method or operating technique that the manufacturer does not specifically recommend, you must satisfy yourself that it is safe for you and others. You must also make sure that the procedure, work method or operating technique that you choose does not render the transfer switch unsafe.

WARNING

Contact with live parts can cause electric shock or burn.

•Licensed electrician must perform installation of transfer switch.

•Follow all applicable federal, state and local codes, standards and regulations.

WARNING

Failure to properly ground transfer switch can result in electrocution.

•DO NOT touch bare wires or receptacles.

•DO NOT use transfer switch with worn, frayed, bare or otherwise damaged wiring.

•DO NOT handle electrical cords while standing in water, while barefoot, or while hands or feet are wet.

•If you must work around a unit while it is operating, stand on an insulated dry surface to reduce shock hazard.

•DO NOT allow unqualified persons or children to operate or service transfer switch.

•In case of an accident caused by electrical shock, immediately shut down the source of electrical power and contact local authorities. Avoid direct contact with the victim.

WARNING

Transfer Switch contains hazardous voltage that can cause personal injury or death.

•Despite the safe design of the transfer switch, operating this equipment imprudently, neglecting its maintenance or being careless can cause possible injury or death.

NOTICE

Improper treatment of transfer switch can damage it and shorten its life.

•Use transfer switch only for intended uses.

•If you have questions about intended use, ask dealer or contact Briggs and Stratton Power Products.

•DO NOT expose transfer switch to excessive moisture, dust, dirt, or corrosive vapors.

•Remain alert at all times while working on this equipment. NEVER work on the equipment when you are physically or mentally fatigued.

•If connected devices overheat, turn them off and turn off their circuit breaker/fuse.

3