Briggs & Stratton Portable Generator Troubleshooting, Problem, Cause, Correction, are connected

Models: Portable Generator

1 48
Download 48 pages 22.5 Kb
Page 20
Image 20
Troubleshooting

Troubleshooting

Problem

Cause

Correction

 

1.

One of the circuit breakers is open.

1.

Reset circuit breaker.

Engine is running, but no AC

2.

Fault in generator.

2.

Contact authorized service facility.

3.

Poor connection or defective cord set.

3.

Check and repair.

output is available.

4.

Connected device is bad.

4.

Connect another device that is in good

 

 

 

 

 

condition.

 

 

 

 

 

Engine runs good at no-load

1.

Short circuit in a connected load.

1.

Disconnect shorted electrical load.

2.

Engine speed is too slow.

2.

Contact authorized service facility.

but "bogs down" when loads

3.

Generator is overloaded.

3.

See Don't Overload Generator.

are connected.

4.

Shorted generator circuit.

4.

Contact authorized service facility.

 

 

 

 

 

 

 

1.

Engine switch set to "Off".

1.

Set switch to "On".

 

2.

Fuel valve is in "Off" position.

2.

Turn fuel valve to "Open" position.

 

3.

Low oil level.

3.

Fill crankcase to proper level or place

 

 

 

 

generator on level surface.

 

4.

Dirty air cleaner.

4.

Clean or replace air cleaner.

 

5.

Out of fuel.

5.

Fill fuel tank.

 

6.

Stale fuel.

6.

Drain fuel tank and carburetor; fill with

Engine will not start; or starts

 

 

 

fresh fuel.

7.

Spark plug wire not connected to spark

7.

Connect wire to spark plug.

and runs rough.

 

plug.

 

 

 

 

 

 

 

8.

Bad spark plug.

8.

Replace spark plug.

 

9.

Water in fuel.

9.

Drain fuel tank and carburetor; fill with

 

 

 

 

fresh fuel.

 

10.

Flooded.

10.

Wait 5 minutes and re-crank engine.

 

11.

Excessively rich fuel mixture.

11.

Contact authorized service facility.

 

12.

Intake valve stuck open or closed.

12.

Contact authorized service facility.

 

13.

Engine has lost compression.

13.

Contact authorized service facility.

 

 

 

 

 

Engine shuts down when

1.

Out of fuel.

1.

Fill fuel tank.

2.

Low oil level.

2.

Fill crankcase to proper level or place

running.

 

 

 

generator on level surface.

 

 

 

 

 

 

 

 

 

Engine lacks power.

1.

Load is too high.

1.

See Don't Overload Generator.

2.

Dirty air filter.

2.

Replace air filter.

 

 

 

 

Engine "hunts" or falters.

Carburetor is running too rich or too lean.

Contact authorized service facility.

 

 

 

 

 

20

BRIGGSandSTRATTON.COM

Page 20
Image 20
Briggs & Stratton Portable Generator manual Troubleshooting, Problem, Cause, Correction, output is available, are connected