4. Make sure black detergent nozzle is installed.
NOTE: Detergent cannot be applied with the high pressure ProjectPro™ nozzle (Orange, Yellow or Red).
5.Make sure garden hose is connected to water inlet. Check that high pressure hose is connected to spray gun and pump. Turn on water.
NOTICE
You must attach all hoses before you start the engine.
•Starting the engine without all the hoses connected and without the water turned ON will damage the pump.
•Damage to equipment resulting from failure to follow this instruction will void warranty.
6.Start engine following instructions How to Start Your Pressure Washer.
7.Apply detergent to a dry surface, starting at lower portion of area to be washed and work upward, using long, even, overlapping strokes.
8.Allow detergent to "soak in" for
IMPORTANT: You must flush the detergent siphoning system after each use by placing the filter into a bucket of clean water, then run the pressure washer in low pressure for
Pressure Washer Rinsing
For Rinsing:
1.Remove black detergent nozzle from nozzle extension.
2.Select and install desired high pressure nozzle following instructions How to Use ProjectPro™ Nozzle System.
3.Keep the spray gun a safe distance from the area you plan to spray.
WARNING
Kickback from spray gun can cause you to fall.
•Operate pressure washer from a stable surface.
•Be extremely careful if you must use the pressure washer from a ladder, scaffolding, or any other similar location.
•Firmly grasp spray gun with both hands when using high pressure spray to avoid injury when spray gun kicks back.
4.Apply a high pressure spray to a small area, then check the surface for damage. If no damage is found, it is okay to continue cleaning.
5.Start at the top of the area to be rinsed, working down with same overlapping strokes as you used for washing and applying detergent.
Cleaning Detergent Siphoning Tube
If you used the detergent siphoning tube, you must flush it with clean water before stopping the engine.
1.Place detergent siphoning tube/filter in a bucket full of clean water.
2.Remove high pressure nozzle from nozzle extension.
3.Select and install black detergent nozzle following instructions How to Use ProjectPro™ Nozzle System.
4.Flush for 1-2 minutes.
5.Shut off engine following instructions How to Stop Pressure Washer and turn off water supply.
6.ALWAYS point gun in a safe direction and press red button and squeeze spray gun trigger to release retained high water pressure.
IMPORTANT: Spray gun traps high water pressure, even when engine is stopped and water is disconnected.
WARNING
The high pressure stream of water that this equipment produces can cut through skin and its underlying tissues, leading to serious injury and possible amputation.
Spray gun traps high water pressure, even when engine is stopped and water is disconnected, which can cause injury.
•Keep high pressure hose connected to pump and spray gun while system is pressurized.
•After each starting attempt, where engine fails to run, always point spray gun in safe direction, press red button and squeeze spray gun trigger to release high pressure.
Automatic Cool Down System (Thermal Relief)
If you run the engine on your pressure washer for
the warm water onto the ground.
16 | BRIGGSandSTRATTON.COM |
