26

Note: When performing Step 10,

Lift grill body from front and

rear panels to avoid injury to

hands and fingers. Be sure

to pass hose/regulator

assembly above cart frame

crossbar.

Step 10

With the help of a friend, place grill

body assembly on preassembled

cart frame. Grill body will rest on

angled top of vertical supports.

Align bolt holes located on the

outside of the grill body assembly.

Secure using four M6 X12mm bolts

with small star washers.

ELECTRONIC IGNITER
FOR ASSISTANCE,CALL 800-527-0717
FOR OUTDOOR
USE ONLY
BURNERCENTER
7. To light the left and right
burners, push and turn
control knobs to HIGH.
Follow Step 6.
8. Refer to owner’s manual
for match lighting
procedure.
9.To turn off, turn each
control knob clockwise
until it locks in OFF
position.
NOTE: Turn off LP supply
at cylinder when
appliance is not in use.
GRILL LIGHTING INSTRUCTIONS:
1. Read and follow all warnings
and instructions in owner’s
manual before lighting.
2. Open lid before lighting burner.
3. Make sure all control knobs are
in the OFF position.
NOTE: The CENTER BURNER must
be lit first, then light the left and
right burners.
4. Push and turn the control knob for
the CENTER BURNER to HIGH.
5. Press the electronic igniter and
hold for 3-5 seconds to light burner.
6. If ignition does not occur in
5 seconds, turn control knob
to OFF, wait 5 minutes to allow gas
to dissipate and repeat lighting
procedure.

Grill Body

Assembly

ELECTRONIC IGNITERFOR ASSISTANCE,CALL 800-527-0717
FOR OUTDOOR
USE ONLY
BURNERCENTER
7. To light the left and right
burners, push and turn
control knobs to HIGH.
Follow Step 6.
8. Refer to owner’s manual
for match lighting
procedure.
9.To turn off, turn each
control knob clockwise
until it locks in OFF
position.
NOTE: Turn off LP supply
at cylinder when
appliance is not in use.
GRILL LIGHTING INSTRUCTIONS:
1. Read and follow all warnings
and instructions in owner’s
manual before lighting.
2. Open lid before lighting burner.
3. Make sure all control knobs are
in the OFF position.
NOTE: The CENTER BURNER must
be lit first, then light the left and
right burners.
4. Push and turn the control knob for
the CENTER BURNER to HIGH.
5. Press the electronic igniter and
hold for 3-5 seconds to light burner.
6. If ignition does not occur in
5 seconds, turn control knob
to OFF, wait 5 minutes to allow gas
to dissipate and repeat lighting
procedure.